2018+ JL WRANGLER FULL
-
WIDTH FRONT
Page ( 3 of 8 )
www.
ROADARMOR
.com
INSTALL INSTRUCTIONS
1
Unscrew the eight (8) plastic screws in the center of the retainer clips securing the factory air dam
TIP
If the screws just spin use a flathead screwdriver or small pry bar to pop them out.
2
Unscrew two (2) bolts on the bottom side of the front splash shield and remove.
3
Unplug main bumper harness from outside passenger frame rail.
4
Unscrew two (2) bolts on the bottom side of the front skid and remove.
1
2
4
5
5
Remove the two nuts one bolt holding the factory bumper and stiffeners on, four (4) on each side of
the frame using an 18mm socket and/or wrench. Keep ALL stiffeners for installing Road Armor
Bumper.
1
3
