4
The audio instruction card inside the packaging has eight embossed
sound spots which play back audio instructions about how PenFriend
works, on one side, and 15 sound spots on the reverse side detailing
uses for your PenFriend.
The eight instruction hotspots have rectangular raised areas which you
can feel and inside each rectangle is an instruction. From top to bottom
of the card:
•
General information.
•
Power.
•
Record.
•
Volume.
•
Mode.
•
Saving files.
•
Download.
•
Batteries.
Switch on the PenFriend by pressing the large protruded top button for
two seconds. You will hear a bleep. Simply tap the thin end of
PenFriend on any of the hotspots and it will read out loud the relevant
instructions. Move onto the next tactile hot spot to learn more.
Getting started
Your PenFriend audio labeller is supplied with two AAA batteries
installed. To save battery life the device switches off after 10 minutes of
no use. It will give an audible CHING to notify you. If you use
headphones the battery life is maximised by not using the speaker.
Lanyard attachment
Take the PenFriend lanyard and attach the metal end by pulling the
spring lever back and threading the metal hook through the loop at the
end of the pen. Release the lever and the lanyard will stay securely in
place. At the opposite end of the lanyard is a plastic connector with a
safety latch. Should the lanyard be tugged it will split open to protect
your neck. You can snap the plastic back into position to continue.
