Gill 4 Fixed Backrest Units only.
Fixed Back Gill 4 Seat Units, will be supplied with the Backrest pre-set to the
angle requested on the initial prescription (90°, 95° or 100°).
This angle should
only be changed by a suitably qualified person, following the instructions
enclosed with the alternative Angle Positioning Insert Kit, available from
RMS Sales.
FOOTRESTS (Optional)
Tools Required: 4 and 5mm Hexagon Keys.
The Footrest Frame assembly, complete with
multi-positional footplates mounted on a height
adjustable cross-frame is inserted into the front of
the Seat Rails and secured in place by a Ball
Locking Pin located at each side of the Seat
Fig.17. Removal, is by depressing the centre
button on each Locking Pin and fully withdrawing
both Pins. Slide the Frame assembly forwards,
clear of the Seat Unit.
Height adjustment of the
Footrests is made by
slackening both Cross
Frame Mounting Clamps
Fig.18,
to
allow
the
Frame to be raised or
lowered to the required
height.
Retighten
all
clamping screws evenly,
sufficient to prevent any
movement.
T he
m ulti-positional
Footrests
are
angle
adjustable by their ability
to rotate around the
Cross Frame.
To change the angles or positions of the Footrests, slacken all four clamping
screws on each Footplate, rotate / re-position as required and re-tighten all
clamping screws evenly.
The Footrests may also be positioned either further forward or rearward of their
supplied central mounting position, by removing all clamping screws on each
Footrest and repositioning the Footrest over it’s clamp. All screws must be
tightened evenly to ensure maximum clamping on the Cross Frame and
sufficient to prevent movement.
11
Fig. 17
Fig. 18
Ball Locking
Pin
Footrest Cross Frame
Mounting Clamp
Footrest Mounting
Clamp Screws with
alternative
mounting positions
