RMG TME400, Operating Manual

Page: 71 / 156

4 Operation
MANUAL TME400-VCF · EN08 · July, 01 st 2021
65
A22 Digital output 2
pulse width
A22 digital output 2 pulse width
20 ms
125 ms (default)
250 ms
Coor-
dinate
Name Modbus
register
Modbus
access
Protec-
tion
Data
type
Min. Max. Default Unit
A01 Standard volume
300
W
E
uint32 0 99999999 0
m
3
A02 Operating volume
302
W
E
uint32 0 99999999 0
m 3
A03 Standard volume error
304
W
E
uint32 0 99999999 0
m 3
A04 Operating volume error
306
W
E
uint32 0 99999999 0
m 3
A05 Uncorrected operating
volume
308 W
E
uint32 0 99999999 0 m 3
A06 Volume Start/Stop
310
W
N
uint32 0 99999999 0
m 3
A07 Volume Reset
312
W
N
uint32 0 99999999 0
m 3
A10 Meter factor
500
W
E
string12
* * 1000.0 I/m
3
A11 Output pulse factor
506
W
E
float 0.01 100 1.0
I/m
3
A12 Meter factor corrected
508
R
A
float - - 1.0
I/m
3
A20 Display factor
510
W
E
menü16 0 4 2
A21 Digital output 2 mode
511 W
E
menü16 0 1 0
A22 Digit. output 2 pulse width 512
W
N
menü16 0 2 1
ms
4.3.3.2.
Flow rate
Coordi-
nate
Name Description
B01 Standard flow rate Flow value under standard conditions (see above)
B02 Operating flow rate Flow rate under current operating conditions
B03 Frequency Unchanged output value, frequency of Sensor 1.
B05 Min. flow rate An alarm is generated below this flow rate
B06 Max. flow rate An alarm is generated above this flow rate
B10,
B11,
B12,
B13,
B14,
B15
Coefficients:
A-2, A-1, A0, A1, A2
Max. operating point
deviation
Z26: If the characteristic correction is deactivated, the additional pa-
rameters are not visible and cannot be adjusted. If a characteristic
correction is activated (see Z26 below), a correction takes place with
the factors in:
B10: Factor for the characteristic correction
B11: Factor for the characteristic correction
B12: Factor for the characteristic correction
B13: Factor for the characteristic correction
B14: Factor for the characteristic correction
B15: If the deviation of the corrected from the uncorrected
characteristic at an operating point (or a range) is more than