1. INTRODUCTION
Our GSM Pump Controllers (Mobile Pump Starter) are very unique and
specially designed for farmers, agriculturists and industries to operate and
monitor remotely located motor pumps. They can switch ON and switch OFF the
motor pumps from their homes or anywhere by using a SMS / CALL / Android
Application. It also saves water, time and electricity. Our GSM based mobile pump
controller are manufactured with advanced embedded micro controller
technology and quality process.
2. DESCRIPTION
Ÿ
POWER ON/OFF SWITCH:
Used to Power ON/OFF the controller.
Ÿ
POWER ON LED:
It indicates power supply to controller.
Ÿ
MOTOR ON LED:
It glows when the motor is in ON condition.
Ÿ
GSM SIGNAL LED:
It indicates the status of GSM network signal. If this LED
blinks for every 3 seconds signals are good and available. If this LED blinks for
less than 1 seconds or does not blink, signals are not available.
Ÿ
Fuse Holder:
It has 300mA fuse to protect the controller from power surges. If
fuse fails replace them.
Ÿ
Antenna Connector:
It is used for connecting the given 3dbi antenna provided.
Ÿ
Terminals:
3. TOOLS REQUIRED
Ÿ
Drilling Machine
Ÿ
Simple hammer
Ÿ
Wooden gattas
Ÿ
Insulation tape
Ÿ
Screws for mounting units on wall
Ÿ
Line tester
Ÿ
Wire stripper,
1
1
COMMON
START RELAY
(BLUE PAIR WIRES)
2
NO (Normally Open)
3
COMMON
STOP RELAY
(BLACK PAIR WIRES)
5
NC (Normally Close)
5
Phase/R-Line
AC 230/440 V
(RED & BLACK WIRE)
6
Neutral/L-Line
