RME Audio Babyface Pro, User Manual

Page: 60 / 94

60 User's Guide Babyface Pro © RME
21.8.2 MIDI Page
The MIDI page has four independent settings for up to four MIDI remote controls, using CC
commands or the Mackie Control protocol.
Index
Select one of four settings pages and thus remote controls. Settings are remembered automati-
cally. To activate or deactivate any of the four remote controls check or uncheck ‘In Use’.
MIDI Remote Control
¾
MIDI In.
Input where TotalMix receives MIDI Remote data.
¾
MIDI Out.
Output where TotalMix sends MIDI Remote data.
¾
Disable MIDI in background.
Deactivates MIDI Remote Control as soon as another appli-
cation is in the focus, or when TotalMix has been minimized.
Mackie Control Options
¾
Enable Protocol Support.
When
disabled TM FX will only react on the
Control Change commands of chapter
24.5.
¾
Extender to.
Sets the current remote
to be an extender to the main remote.
Both remotes will be shown as one
block and navigate simultaneously.
¾
Map Stereo to 2 Mono Channels.
One fader controls one (mono)
channel. Should be disabled when
stereo channels are used.
¾
Submix Selection in Input/Playback
Row.
Enables a selection of the
submix when in first row, without
having to change to the third row first.
However, when using both mono and
stereo channels first and third row
usually do not match anymore, so the
selection often becomes unclear this
way.
¾
Enable full LCD support.
Activates
full Mackie Control LCD support with
eight channel names and eight
volume/pan values.
¾
Send User defined Names.
Channel
names defined by the user will be sent
to the remote device via MIDI and – if
supported – shown in its display.
¾
Send Level Messages.
Activates the transmission of the level meter data.
Peak Hold
acti-
vates the peak hold function as set up for the TotalMix level meters in the preferences.
Note: When MIDI Out is set to NONE then TotalMix FX can still be controlled by Mackie Control
MIDI commands, but the 8-channel block is not marked as remote target.