- this appliance must be connected to an earthed power socket.
WARNING
Remove all the package materials before using.
The heater is fitted with a supply cable and molded plug, therefore the terminals
should not be interfered with. The following points should be considered when
positioning the heater:
1.
2.
3.
4.
5.
6.
7.
8.
If you use the heater for the first time, observe it for the first 10-15 minutes in
case of interference.
Before use, make sure that the appliance is not damaged, it is properly
installed, in its heating radius there are no obstructions and that the current
of the power socket is correct (220-240V/50-60Hz)and that is grounded.
If everything is ok, insert the plug into the power socket.
Install 2 x 1.5V(AAA) batteries into the remote control.
Turn the power switch to the ON position.
Select the appropriate power.
To turn off the heater, press the OFF button on the remote control.
Press the power switch of the appliance to the OFF control.
Take the power cord out of the socket after turn off the product.
●
●
●
●
In the event of heater failure, or for spare parts or advice, please contact
the manufacture in the first instance.
Disconnect from the mains before commencing any maintenance procedure
including cleaning.
To ensure optimum heat effectiveness, it is recommended that after the heater
has been used for approximately 80-100 hours, that the guard and lamp are
removed and the reflector is wiped with a lint-free cloth before reassembling.
If the supply cord becomes damaged, it must be replaced by the manufacturer,
its service agent or a similar qualified person.
3
Technical Specifications
Usage
Power consumption
Power supply
IP rating
Radiation range
2000 W
220-240V 50Hz
IPX5
3m