DIN Rail Mounting
The DIN clip for mounting the system is mounted onto the rear panel. Hook the DIN clip on the top flange of the
DIN rail and rotate to the locked position to install. To remove, push up to depress the spring latch and rotate off of
the DIN rail.
"
DIN Rail Mounting
Wall Mounting
The system can be easily wall mounted by attaching the provided wall mount ears and hardware. Attach the wall
mount ears by following the instructions below.
"
Wall Mounting
Connect Optical Fiber Cable
The optical ports may be equipped with ST or SC fiber connectors. A fiber pair is required for operation with dual
fiber models, TX is the signal output side and RX is the signal input side. Single fiber models (bi-directional)
combine input and output, by using different wavelengths over one fiber.
Connect fiber cables to correct TX and RX ports. On dual fiber models, Verify that the TX fiber at one module is
connected to the RX port on the opposite end. On single fiber systems there will be an
A
and
B
side. The
A
side
must connect to the
B
side.
Do not remove fiber cable caps until you connect fiber to the unit, watch for dust and contamination. Fiber cables
should be routed loosely avoiding tight bends to prevent excessive optical loss.
DIN
Rail
Click
DIN
Rail
Push Up
Installation
Removal
1
Replace
connector.
Attach
Wall Mount Kit.
Left Side
Remove
connector.
Mount to wall
using supplied
hardware.
Right Side
2
3
4
Wall
Mount
Kit
Remove
screws.
RLH Industries, Inc. • Tel. 866-DO-FIBER • Fax 714 532-1885 • www.fiberopticlink.com
Page
"
6
