24 • Chapter 4: Startup and Operation
AirLink 7010 Gas Monitor Operator’s Manual
Holding Channels
This feature can be used to monitor a select channel, rather than the continuous scanning of channels
while in Normal Operating Mode.
1. Open the enclosure box.
2. Locate
SCAN/HOLD
on the Front Panel.
3. Press
SCAN/HOLD
once to “freeze” the channel scan sequence.
4. Press
ESC
to return to Normal Operating Mode.
NOTE:
The device will automatically return to Normal Operating Mode after five minutes of
inactivity.
5. Close the enclosure box.
6. Clamp down the enclosure latches.
LED Functionality
1. Press and release
RESET/ESC
to clear an alarm indication once the alarm condition has cleared.
LED
Color / Status
Description
ALARM 1
off
No alarm condition has occurred on relay 1 since the last reset or power up
solid red
An alarm condition is currently happening on relay 1
blinking red
An alarm condition has occurred on relay 1, but condition has now gone
ALARM 2
off
No alarm condition has occurred on relay 2 since the last reset or power up
solid red
An alarm condition is currently happening on relay 2
blinking red
An alarm condition has occurred on relay 2, but condition has now gone
ALARM 3
off
No alarm condition has occurred on relay 3 since the last reset or power up
solid red
An alarm condition is currently happening on relay 3
blinking red
An alarm condition has occurred on relay 3, but condition has now gone
ALARM 4
off
No alarm condition has occurred on relay 4 since the last reset or power up
solid red
An alarm condition is currently happening on relay 4
blinking red
An alarm condition has occurred on relay 4, but condition has now gone
Fault
off
No Fault condition has occurred on any sensor unit since the last reset or
power up
solid orange
A Fault condition is currently happening on at least one sensor unit
POWER/STATUS red
A Fault condition is occurring on the monitor
blue
Normal Operating Mode
