RJG IA2-M-DFT, Product Manual

Page: 10 / 20

Lynx™ Digital Flow‑Temperature Interface Module IA2‑M‑DFT | Product Manual 4 RJG, Inc.
INSTALLATION SPECIFICATIONS
The instructions that follow are a general guide;
actual steps necessary to install this product
will vary based on injection molding machine
manufacturer, model, and otptions.
REQUIREMENTS
CAUTION Before beginning IA2‑M‑DFT
installation, disconnect and lockout/tagout any
and all power to the molding machine. Failure to
comply will result in personal injury or death, and
damage or destruction of equipment.
MOUTING
Mount the IA2‑M‑DFT module to a solid
surface—such as the molding machine frame—
using the supplied 1.38” (35 mm) DIN rail. A
clearance height of 6.0” (152,4 mm) from the
face of the module is recommended. Connect
the IA2‑M‑DFT to the ID7‑M‑SEQ or DIN/
LX‑M using the side‑integrated amphenol
connector.
NOTE Modules and connecting cables must
be located away from any static sources, such as
feeder tubes and material hoppers.
WIRING
Attach the supplied cable to the
Smartflow® TracerVM™with User Interface
flow‑temperature meter on one end, and
connect to the IA1‑M‑DFT on the other using
the four‑pin connector.
A Lynx cable CE‑LX5 must connect the
ID7‑M‑SEQ or DIN/LX‑M to the eDART
System.