OPERATING MANUAL
RL 6100
Page
10
Prepared by:
O.
Č
áp
RIVETEC E120626
4. MAINTENANCE
The user may only perform the activities described below, other maintenance and repair is
authorized to carry by the manufacturer or its authorized service centers.
4.1 Adding hydraulic oil, venting of the hydraulic
1. Disconnect the tool from any compressed air
2. Clamp the tool horizontally in a vice
3. Unscrew the filling oil screw by the internal hex key 4
4. Screw the filling adapter instead of screw
5. Fill the syringe with hydraulic oil and place it into the adapter
6. Add oil to the bottom visible thread rotation
7. Remove the syringe and remove the filling adapter
8. Give back the adding oil screw and tighten with internal hex key 4
9. Remove the tool from the vice and connect the compressed air supply
10. The tool is ready for use opln
ě
ní hydraulického oleje, odvzdušn
ě
ní hydraulické
č
ásti
4.2 Punching system cleaning
1. Keep the punching pin and nose cap cleen! To ensure the free movement of pin and
centering pin the chips must be removed during all the operation!
Manufacturer’s address:
RIVETEC spol. s r.o.
Tel.: +420 382 206 711
398 16 Albrechtice Nad Vltavou
Fax: +420 382 206 719
Albrechtice Nad Vltavou 16
www.rivetec.eu
Czech Republic
E-mail: [email protected]
