Rivet King FreeSet RK-777-1, Manual, Page: 22 / 31

18
5.3 Approved Lubricants
The tool must not be cleaned with fat-solvent agents or water.
5.4 Removing The Jaws
 Remove the outer sleeve.
 Remove the nose case
 Pull back the spring located on the nose

Remove the jaw case while the spring plunger is in the back position

Remove the jaws from the jaw case

Clean with mineral based cleaning agent and check wear off all components.

Replace as necessary and re-install in the reverse order
5.5 Removing The Nose Piece

Remove the nose piece from the nose case with a 12mm wrench.

Clean and replace as necessary or select another nose piece from the list offered in 3.2.

Re-install the nose piece in the reverse order
Warning!
The guide tube in the blind riveter has a diameter of 5mm. Some fasteners
may need a larger diameter. In this case a special configuration of the tool
may be required. See section 3.2 for guide tube options. Contact your
RivetKing® representative for assistance.