R-1
F-1
W-8
G-1
F-1
G-1
W-8
R-1
F-1
W-8
WWW.RSIWW.COM
35 of 48
NOTE: VIEWS FROM OUTSIDE.
Fit one F-1 profile next to right
panel. F-1 profile rests against
widest part of roof ridge and lines
up with top of gutter.
8.3c
Repeat step 8.3C through 8.3D to secure install and secure F-1 profile on left side.
8.3e
Repeat step 8.3B through
8.3F to install the next two
W-8 panels and F-1 profiles.
8.3G
8.3A
8.3B
W-8
W-8
W-8
W-8
8.3F
Hold two profiles together in place at ridge using one B-4
connector. Insert two T-bolt assemblies, line up center hole
with long hex bolt in roof ridge. Secure T-bolt assemblies as
shown.Place washer on long bolt and secure with S-2C cap.
F-1
F-1
R-1
B-4
Remove bungee cord nearest to back.
Remove plastic film from both sides of
one W-8 panel. With side marked “ UV
Resistant” facing outside, install the
next panel on the left at the back.
Push panel into roof ridge channel until
the other end rests on gutter ledge
and then slide towards F-1 profile
at back.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
From inside, hold profile in
place with one B-4 connector.
Secure with two T-bolt
assemblies as shown.
8.3D
F-1
B-4
F-1
Connectors
QTY
B-4
4
Connectors
QTY
S-2C
6
S-7
6
Panel
QTY
W-8
4
24” x 57”
24” x 57”
Profile
QTY
F-1
4
56”
56”