Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
7
Operator's Manual
Syct
™
2-Man Ladder Stand
11. a. Attach the two shooting rail stop mounts (16) to the side seat
support loops (8) using two 1/4-20 x 1-1/2” bolts (22) and locknuts
(27). Be sure that each mount is oriented to the outside of each
side seat support loop. SEE FIGURE 8.
b. Press two rubber bumper stops (32) into the top side hole of
each stop mount (16). SEE FIGURE 8.
12. Attach the two shooting rail receiver tubes (15) to the outside of
each side seat support loop (8) using two 1/4-20 x 2-3/4” bolts
(25), yellow washers (30), nylon spacers (31) and locknuts (27).
SEE FIGURE 8.
13. Insert the shooting rail rim (14) into the shooting rail receiver
tubes (15) and secure together using two 1/4-20 x 1-1/2” bolts (22),
four yellow washers (30) and two locknuts (27). SEE FIGURE 9. You
must now tighten all nut and bolt assemblies. Be sure not to
over tighten or crush tubing when tightening.
14. Sections are assembled on the ground in the following order;
bottom ladder section (1); middle ladder section (2); top ladder
section (3); assembled platform section. SEE FINISHED LADDER.
15. With all sections assembled together on ground, secure all
sections together using six silent knob assemblies (21). These
knob assemblies consist of a simple threaded knob with carriage
bolt. Thread the knob onto carriage bolt only about 2 turns. Insert
the head of carriage bolt into the large end of the key hole type
opening in ladder pocket and slide the square “block” portion
of carriage bolt head down into the slot. Doing this will capture
the square “block” portion of carriage bolt and hold it in place.
Tighten the knob by hand until tight which will draw the two
ladder sections together and eliminate any slack between the
ladder sections. SEE FIGURES 10A AND 10B.
16. Attach the two support braces (12) to the outside of platform
J-pipes (6) and top ladder section (3) with mounting holes using
four 1/4-20 x 2-1/4” bolts (23) and locknuts (27). SEE FIGURE 11.
Tighten securely. Be sure not to over tighten or crush tubing
when tightening.
FIGURE 10A
21
FIGURE 11
3
27
23
12
6
FIGURE 8
27
31
30
25
15
22
32
16
27
FIGURE 9
27
30
14
22
30
15
FIGURE 10B
key hole
opening
21
