Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
10
Operator's Manual
XL Ladder Stand
SETUP AND USE INSTRUCTIONS
1. With assembled product lying on the ground, position one
person at bottom end of ladder lying on the ground. This
person has to prevent the ladder end from tilting up when
platform end is lifted and prevent the ladder from skidding
across ground.
2. a. Position two people at the platform end of the ladder,
lift the platform end and continue uprighting by walking
toward bottom end of ladder and moving hands along
ladder legs. Stand ladder up against chosen straight tree
on dry, level ground. Use caution when ladder comes over
center against the tree. SEE FIGURE 10A
b. Step back and look at the ladder top to see that it is level.
Adjust as needed to achieve a level platform top. Make sure
tree blade is contacting tree. SEE FIGURE 10B
c. Step down hard on bottom step to push ladder legs into
the ground. SEE FIGURE 10C
3. While two people hold the stand in place, the third person
should connect the horizontal stabilizer bar to the tree.
Adjust the length of the stabilizer bar as need so it contacts
the tree and is level to the ground. Then secure it to the
tree with the 6' cam strap (40) by forming a cinch knot with
both ends of the strap and running the long end of the
strap through the cam buckle. SEE FIGURES 11 and 12.
During installation and removal of ladder treestands, you
must always and properly use the included Full Body Harness
(Fall Arrest System). Refer to the Full Body Harness instructions
included with this product for proper use.
FIGURE 11
FIGURE 12
A
A
B
C
FIGURE 10
