Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
8
Operator's Manual
XL Ladder Stand
13
23
30
12
33
18. Assemble the horizontal stabilizer bar as follow:
a. Slide the stabilizer bar (12) into stabilizer bar extension
tube (13) and secure together with spring lock pin (30).
SEE FIGURE 8
NOTE: Spring lock pin (30) must go through both the
horizontal stabilizer bars at the appropriate hole to
achieve the desired distance from the tree. Adjustment
in length may be needed when ladder is up righted
later in instructions.
b. Attach the forward end of the horizontal stabilizer bar
assembly to a rung of the ladder using 5/16-18 x 1-3/4"
bolt (23) and 5/16" wing nut (33). SEE FIGURE 8
19. Preassemble 16’ stabilizer straps (42) and 6’ ratchet strap (41)
as follows:
a. Attach the two long ends of the 16’ stabilizer (criss-cross)
straps (42) to each side of the seat side rail (9) between
the armrests and the tree blade. These long stabilizer
straps should be attached by pulling the free end of the
strap through the loop end of the strap to create a cinch
knot around the rail tube. SEE FIGURE 9
b. To aid in the ease of installation, pre-attach each end of
the 6’ ratchet strap (41) to each side of the seat side rail,
between the 16’ stabilizer straps (42) and the tree blade.
Use the same method as above. SEE FIGURE 9. This
way each end of the main ratchet strap is pre-attached
before the stand is lifted from the ground. SEE FIGURES
10 AND 11 showing the locations of the four ends
attached.
42
41
41
42
9
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
