Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
10
Operator's Manual
CLASSIC XT 1-Man Ladder Stand
1. Select a straight, healthy tree. Do Not attempt to install on a tree
that is not healthy.
2. With assembled product lying on the ground, position one person
at bottom end of ladder lying on the ground. This person has to
prevent the ladder end from tilting up when platform end is lifted
and prevent the ladder from skidding across ground.
3. a. Position two people at the platform end of the ladder, lift the
platform end and continue uprighting by walking toward bottom
end of ladder and moving hands along ladder legs. Stand ladder
up against chosen straight tree on dry, level ground. Use
caution when ladder comes over center against the tree. SEE
FIGURES 8(A).
b. Step back and look at the ladder top to see that it is level. Adjust
as needed to achieve a level platform top. Make sure tree blade is
contacting tree. SEE FIGURES 8(B).
c. Step down hard on bottom step to push ladder legs into the
ground. SEE FIGURES 8(C).
4. While two people hold the stand in place, the third person should
connect the horizontal stabilizer bar to the tree. Adjust the length
of the stabilizer bar as need so it contacts the tree and is level to
the ground. Then secure it to the tree with the 6' cam strap (24)
by forming a cinch knot with both ends of the strap and running
the long end of the strap through the cam buckle. SEE FIGURES 9
and 10.
SETUP AND USE INSTRUCTIONS
During installation and removal of ladder treestands, you
must always and properly use the included Full Body Harness
(Fall Arrest System). Refer to the Full Body Harness instructions
included with this product for proper use.
WARNING
Never use a treestand on a dead, leaning, diseased or
loose barked tree, or a utility pole. Always avoid electrical
power lines.
A
A
B
C
FIGURE 8
FIGURE 9
FIGURE 10
B
A
C
D
E
FIGURE 11
