MODEL NO.: River of Goods
Ceiling Fan Remote &
Receiver
1
Installation Guide
MODEL NO.: River of Goods Ceiling Fan Remote & Receiver
IMPORTANT:
You must set the ceiling fan manual pull chain switch to
HIGH speed and light kit to ON position to ensure proper operation of
the remote control.
WARNING:
Failure to disconnect power prior to the installation may result in serious injury and fire hazard.
Instructions
1.
Set the codes on the remote and receiver. Codes are set by pushing the dip switches up or down. To ensure
proper syncing and operation of the remote and receiver, the dip switch settings must be identical on each
component
2.
Install the provided batteries (2 x AAA)
CAUTION
: Batteries will weaken with age and should be replaced before leaking takes place as this will
damage the remote. Dispose of used batteries properly, and keep batteries out of reach of children. To reduce the
risk of fire or injury, do not use this product in conjunction with any variable (rheostat) wall control.
3.
Install the receiver in the hanging bracket of the fan.
WARNING
: This unit is intended for use with AC120V 60Hz power only.
Do not install in damp locations or immerse in water. For indoor use only.
Do not pull on or cut the receiver wire leads shorter.
Incorrect wire connection will damage this receiver
4.
Make the wire connections following the diagram below carefully.
CAUTION:
Incorrect wire connection can damage the receiver.
Be sure outlet box is properly grounded or that a ground wire (
GREEN
or bare) is present.
READ AND SAVE THESE
INSTRUCTIONS
