5 Installation
EN
18
Rittal enclosure cooling unit
Fig. 26:
Release the range limiters
Next, pull the lower louvred grille upwards at an angle
out of the bottom holders and set it down in a safe
place.
Fig. 27:
Pull off the lower louvred grille.
All device versions
Apply sealing tape all around the front of the cooling
unit.
Fig. 28:
Apply sealing tape
Start in the top centre of the device to ensure that the
joint edge is not at the bottom of the device where wa-
ter from outside could penetrate.
Fig. 29:
Position the joint edge at the top
For SK 317880x and SK 317980x: At the top left, in-
sert a locator clip so that it latches securely home into
the cooling unit.
Fig. 30:
Latch home the locator clip (for SK 317880x and SK
317980x)
For SK 31848x0: Insert two locator clips at the top so
that they latch securely home into the cooling unit.
Fig. 31:
Latch home the locator clips (for SK 31848x0)
These clips will prevent the cooling unit from falling out
of the mounting cut-out later on before it is properly
secured with the grub screws.
1.
2.
1.
2.
✔
✖
Top
Bottom
CLICK!
CLICK!
1.
2.
CLICK!
CLICK!
CLICK!
1.
2.
