8 Cutting busbars
EN
10
We reserve the right to make technical modifications.
Rittal stationary busbar cutting unit CW 120-S
After triggering an emergency stop:
Turn the emergency stop switch slightly so that it returns to its initial position.
The pump is returned to ready mode. It can then be reactivated by actuating
the foot pedal.
If the emergency stop was activated via the foot-operated switch: release the
foot-operated switch by pressing the blue silicone cover at the side (see fig. 4).
Fig. 4:
Releasing the foot-operated switch
8
Cutting busbars
Loosen the clamping levers on the side guide plates (fig. 1, 6) of the supporting
table and set the guide plates to the width of the busbar.
Warning!
If a dangerous situation occurs when working with the unit,
stop all dangerous movements of the unit without delay.
In a dangerous situation, press the red emergency stop
switch (fig. 1, 1) on the unit to stop the operation!
As an alternative, press the foot-operated switch beyond
the first pressure point. This also causes the work opera-
tion to stop immediately.
Note:
The electro-hydraulic pump is equipped with an emergency stop
power circuit that is activated by the emergency stop switch of the
connected unit to stop the motor immediately and to deactivate the
integrated magnetic valve.
Note:
To extend the service life of the laser, it should be switched off for
longer machining pauses (> 10-15 minutes).
Warning!
When cutting busbars, the blade can be a risk for cutting or
crushing parts of the body.
Ensure that nobody intervenes in the cutting area, in par-
ticular, after starting a cutting operation.
In a dangerous situation, press the red emergency stop
switch on the unit or alternatively the foot-operated switch
beyond the first pressure point to stop the operation!
