Rittal stationary busbar cutting unit CW 120-S
We reserve the right to make technical modifications.
7
5 Available accessories
EN
5
Available accessories
6
Unit description
The "stationary busbar cutting unit" is equipped with a high-performance single-
acting hydraulic cylinder (9) that achieves a cutting force of approximately
23 tons for a maximum pressure of 700 bar.
Fig. 1:
Front and rear view
Key
1
Emergency stop switch
2
Connection socket (7-pin) for the control cable
3
Connection for hydraulic hose
4
Retainer with ball bearings
5
Supporting table
6
Side guide plates
7
Locking lever for retainer
8
Clamping screws for retainer
9
High-pressure hydraulic cylinder
10
Connection socket (4-pin) for the foot-operated switch
11
Holes for fastening to the work table
12
Cutter bar with integrated line laser
13
Blade
14
ON/OFF switch for laser
The cutting force is transferred uniformly via the cutter bar (12) to a replaceable
blade (13).
The single-pedal foot-operated safety switch is connected with the cutting unit
via the 4-pin socket (10). In dangerous situations, an additional emergency stop
switch (1) can stop the pump immediately and return the blade to its initial posi-
tion. The combination of supporting table (5), side guide plates (6) and retainers
(4) ensures a reliable, perpendicular guiding of the busbars. The clamping screws
Available accessories
Model No.
Electro-hydraulic pump
4055.720
Foot-operated switch
4055.712
Support rollers for busbars
4055.714
Tab. 2:
Available accessories
