Section 1
Getting Started
2
1.2
RIB-600Analog receiver assembly
The RIB-600Analog receiver is on any time power is applied. The receiver case must be opened to program the RIB-
600Analog receiver.
1. Loosen the 4 screws in the front corners of the case using the T-25
Torx Security Bit included with the radio. These screws
are retained to the housing with rubber O-rings,
DO NOT
remove the screws from the housing.
2. Separate the case front from the case back.
3.
Program the RIB-600Analog receiver
per the instructions in the Programming section of this manual, leaving the RPS-1B
power supply connected to the radio. Press the
Enter
button twice before re-assembling the case to be sure the RIB-
600Analog receiver is reset and ready for operation.
4. Carefully position the case front onto the case back. Secure the case halves by tightening the 4 captive screws in the front
corners of the case.
PROGRAMMING
Program Button
Program Display
Enter Button
USB Program
Cable Connector
DC Power Connector
for RPS-1B
BNC Antenna Connector
for AFB-1545
Captive Case
Screws (4 corners)
9-Conductor Interface Cable
Orange
600
Balance Audio
Gray
600
Ground
Yellow
600
Balance Audio
Brown
Switch Input Ground
White
Switch Input
Green
Relay Out
Blue
Relay Out
Red
10.5 VDC
Black
Ground
AUX OUT
Phono Jack
Install the Mounting Brackets
Install the RK-RQX-Q-MB mounting brackets included with the product to the
RIB-600Analog case back. Installation can be with the brackets on each side
as shown, or with the brackets top and bottom.