Ritmo MUSTANG 160 V1, Use And Maintenance Handbook

Page: 28 / 33

28
Fault list
The machine is fitted with a disconnect relay which shuts off power supply to the
connector pins when not inserted in the coupling.
The welding can be stopped at any time pressing “START” button again.
THIS EQUIPMENT MUST BE USED EXCLUSIVELY ACCORDING TO THE INSTRUCTIONS GIVEN
IN THIS HANDBOOK. ANY OTHER USES MUST BE CONSIDERED AS IMPROPER AND MAY
PLACE THE OPERATOR AT RISK AND/OR DAMAGE THE MACHINE.
THE STAFF OPERATING THE WELDER MUST HAVE RECEIVED PRIOR TRAINING ON THE USE
OF THIS EQUIPMENT AND MUST BE SUITABLY INFORMED OF CURRENT ACCIDENT-
PREVENTION REQUIREMENTS.
THE MANUFACTURER ACCEPTS NO LIABILITY FOR ANY PERSONAL INJURY OR DAMAGE
TO PROPERTY DUE TO IMPROPER USE OF THIS EQUIPMENT.
Mains voltage or
frequency out of
limits.
Output current
unregulated
Output short-circuit:
(switch off and
restart to restore)
Environment
temperature out of limits
Overheat machine:
(leave the machine
off to cool down)
Welding stopped
by user
Blinking
Blinking
Blinking
Blinking
Blinking