PG
13
PG
14
RE
SE
T
1 2
3
NOTE:
The remote control system for the 8082c operates on external "C" wire power only. The
thermostat must be connected to the "C" wire or a 24vac power source for the remote to function. If
your unit is operating on Batteries only, then the remote function is disabled to protect battery life.
Remote Control
Set Channel on Remote-
ï To set the channel of the remote, slide the CHANNEL switch to
your desired channel number.
Set Channel on the main unit-
ï To set the channel of the main unit, press MENU and touch "CH"
to select the same channel number as the remote and then touch "HOME".
Temporary temperature override -
ï With the Mode switch of the main unit in HEAT or COOL and the unit at the
HOME
screen,
ï When the 8082C recieves a remote command for a
TEMPORARY
adjustment, The
MANUAL OVERRIDE screen comes on showing the new target temperature, and the
temporary icon will be blinking. After about 15 seconds, the home screen will return
showing the room temperature and the new target temperature.
The remote beeps to let you know it is working. The main unit beeps when it recieves a
remote command. The
TEMPORARY
icon comes on which shows the displayed Target
Temperature is different from the programmed setting.
To cancel the Remote temperature overrides -
ï Press the remote's "RESET" button once. The main unit will return to its program.
Temp up
button
Channel
selector
Temp down
button
Temp reset
button
RE
SE
T
1 2
3
CHANNEL
Beep Pattern
The remote beeps once and then 3 seconds
later beeps 1,2,or 3 times (depending on
channel selection) and sends the signal. The
thermostat beeps when it receives the signal.
Note:
The unit sends a one degree increment
for each time you press the
UP
or
DOWN
arrow on the remote. Pressing the remote
once per 3 second interval gives the unit time
to respond to your command. Faster pressing
can give unreliable results.
A23
A23
A23
(MN21)
To Replace Batteries in the remote -
Open the compartment as shown. Insert the A23 (MN21) size
battery as shown and then replace the cover closed.
AUTO Switching
In the AUTO mode, the 8082C will automatically change from heat to
cool as necessary. The AUTO uses the HEAT program for heating and the COOL program
for cooling.
NOTE:
If
TEMPORARY
or
HOLD
is used, the AUTO switching function is disabled.