BLADE ATTACHMENT
The fan blades are set in place on the fan
hub. Raise the blade above the arm of the
hub and allow the blade to slide into the slot
provided on the hub. Each fan blade is then
attached to the hub with a 22 mm bolt that is
provided. Use a wrench to tighten the bolt
securely to 75 ft-lb (102 NM). Clean each
blade with a paper towel to remove
fingerprints and dirt before the blades are
installed. In the event a blade is damaged,
the damaged blade and the blade opposite
must be replaced. Replacement blades are
provided in pairs.
I M P O R TA N T ! ! !
FAN LEVELING
It is important to level the fan hub after blade
attachment. Level the hub by holding a level
across the center of the hub in all directions.
I M P O R TA N T ! ! !
INSTALLATION
REVOLUTION SP FAN
10
Pub. No. RFSP Rev. 5 - December 2010
Summary of Contents for REVOLUTION SP
