5.1 IR Mode:
This mode is used to measure the insulation resistance of a device for a fixed amount of
time. The default time of this test is 45 sec. The steps to do a test in the IR mode are as follows
To enter the IR mode press icon on the home screen. The main measurement
screen will appear.
To setup the basic settings of the mode press the
icon. The control window will
appear as shown below.
Here you can set the voltage using the voltage up and down in steps of 10V below 1000V
and in steps of 25V above 1000V. There is also a standard voltage button to set standard
testing voltages (100V, 250V, 500V, 1000V, 2500V, 5000V).
CHAPTER 5
MEASUREMENT MODES OF THE METER
Software filter
button
min
button
sec
button
11