东方日升新能源股份有限公司
PV module installation and
maintenance manual
RISEN ENERGY CO.,LTD.
主导部门：组件研发中心
Page：NO.8 ,Total 41
Please get contact with local authority agency to confirm if the installation is legally
allowed and meets the installation inspection requirements before installing the PV
system.
When designing the PV system, please be sure to consider about the voltage
change under different temperatures (please check the temperature coefficients of
all PV modules, when the temperature drops, the variable output voltage of the
module will rise).
The shading on the module surface will affect the power generation much, the
module should be installed in the place where the module cannot be shadowed
totally (such as the shadow from building, chimney and tree etc.), and even the
partially shading (such as the dirt, snow and aerial wire etc.) should be avoided.
The modules should be kept inside the original packaging before installation. In the
transportation and storage period, please do NOT damage the packaging. The
packaging cannot be opened unless at the installation site. It is recommended to
open the packaging according to the opening procedure and handle this procedure
carefully. It is forbidden to let the packaged module dropped directly.
Please ensure the correct and proper method of transportation and installation,
otherwise it could cause the module damage.
The maximum limit of the stack layer is defined in the outer packaging carton box,
please do NOT stack the modules more than this limit. Before opening the
packaging, Please keep it in a ventilated, rainproof and dry place.
It is prohibited to stand, climb, walk and jump on the unpacked packaging.
To avoid damaging the module and to avoid affecting the module safety, please
never put any heavy or sharp objects on the front and rear surface of the module at
any time.
When open the packing box, please use the professional and proper tools which
can avoid the inclining and dropping of the module. It is forbidden to put the
