5
SETUP
The RXS255 is completely assembled. All the bolts have been set to the proper
torque and have thread locking compound applied to keep them secure.
RADIO SYSTEM
Your transmitter should have a switch for channel 5. The model setup below is
typical for most transmitters.
CHANNEL ASSIGNMENTS
MODEL TYPE: Airplane
Channel
Aileron
Elevator
Throttle
Rudder
Gear
Direction
normal
normal
normal
normal
normal
Dual Rates
80/100
80/100
80/100
Expo
-30/0
-30/0
-30/0
End Points
100/100
100/100
100/100
100/100
100/100
SWITCH ASSIGNMENTS - Ch 5
Gear
Gear
Gear
-100%
0%
100%
Stability
FPV
Acro
RECEIVER INSTALLATION
The RXS255 comes with an
adapter that converts PWM
(one wire for each channel)
and S.Bus signals so they can
be used by the flight controller.
The wires from a PWM receiver
should connected to channels
1-6 on the adapter. The PPM
cable from the flight controller
should be plugged into
channel 9.
If an S.Bus receiver is being installed, the cable from the receiver should be plugged
into the adapter’s Channel 9 port. The PPM cable goes to Channel 10.
Before installing the receiver,
remove the front body section
so the battery hatch can be
completely opened. There is a
hidden third screw that secures
the front body section to the
frame. Use a 2mm driver to
loosen the hidden screw.
When the part comes loose,
stop turning the hidden screw.
1
2
3
4
5
6
7
8
9 10
