4
ProSound – Installation Instructions
Introduction
RISCO Group’s External Sounder combines high performance and reliability with an exclusive design,
making it the perfect finishing touch for your burglary and fire alarm installations.
ProSound can be connected to any alarm system, or it can be installed on the BUS RISCO Group’s
ProSYS integrated security system. When installed in conjunction with the ProSYS a whole new level
of remote diagnostics and control becomes available, saving you time and reducing repeat site visits
.
Main Features
Long life SLT strobe (patent pending)
UV-treated vandal proof polycarbonate
housing
Double skin with internal metal cover
Auto recharging battery circuit
Automatic low battery disconnection
(below 10.5V) for protection against
battery deep discharge
Double tamper protection (Wall & Cover)
Anti-Approach, anti foam proximity
protection (3cm)
Positive or negative triggering signal
Flexible strobe activation when
connected to RISCO Group’s ProSYS
Remote Diagnostics and Control when
connected to RISCO Group’s ProSYS
Dedicated trouble and anti approach
outputs
Protection from power supply inverted
connection
Installation
The sounder should be mounted in a difficult to access location to minimize tampering risk, on a flat
mounting surface.
To mount the sounder:
!
IMPORTANT:
The sounder is designed to operate under harsh environmental conditions. However,
stormy weather (e.g. heavy rain, snow, or hail) may cause activation of the anti
approach relay (RS200WAP000A). Therefore, it is recommended to mount the sounder
with anti approach protection in an area protected from rain (e.g. under the eaves).
NOTE:
Before wiring the sounder, ensure that the connection to a power source is switched
OFF.
1.
Open the front cover by removing the case locking screw located at the bottom of
the unit.
2.
Hold the mounting pattern template (supplied) against the wall and mark the
locations for the mounting holes (4 mounting holes are available).
Drill the desired
mounting holes and place the screw anchors.
3.
Insert the wires through the hole at the back cover.
4.
Mount the back unit to the wall using the supplied screws, 3.9mm, 32mm length
screws (DIN 7981 3.9X32 ZP).
5.
Remove the internal metal cover by removing the locking screw located at the
bottom of the cover.
6.
Complete all wiring and set the jumpers and DIP-switches as required.
7.
Insert and connect the back-up battery (SLA rechargeable 12V, 2.2 A/H, UL
approved).
8.
Reattach the metal cover and then close the front plastic cover by reattaching the
screw located at the bottom.
Summary of Contents for ProSound
Page 2: ...2 ...
Page 30: ...30 Figura 1 Configurazione BUS Figura 2 Configurazione STAND ALONE ...
Page 48: ...48 ...