28
• Advance the Hour with LAP/RESET till correct in AM or PM.
• Push START/STOP the Minutes will flash, advance the Minutes with LAP/RESET
till correct. (For quick advance hold in the LAP/RESET button)
When all new settings are done, you must push the MODE button to save.
ALARM ON / OFF:
When setting your alarm anytime, the Alarm will automatically default to the “ON” position.
To switch your alarm OFF (or ON again later) when in AL mode press LAP/RESET repeatedly
and the alarm signal (
) will appear or disappear.
HOURLY CHIME ON / OFF:
From NT mode push the MODE button once. AL is displayed second box from left : Push
LAP/RESET until the chime symbol (
) appears for “on” or disappears for “off”.
TM SETTING COUNTDOWN TIMER:
• From NT mode push the MODE button twice.
• TM is displayed in the third box from the left. 00:00:00 displayed.
• Hold down MODE for 3 seconds till “SET” appears in the top right corner.
The SECONDS will also flash.
• Advance the SECONDS with LAP/RESET till correct. (For quick advance
hold in the LAP/RESET button)
• Push START/STOP the Minutes will flash, advance the Minutes with LAP/RESET till correct.
• Push START/STOP the Hours will flash, advance the Hours with LAP/RESET till correct.
When all new settings are done, you must push the MODE button to save.
Use START/STOP to start and or stop the countdown, and push and hold LAP/RESET
for 3 seconds to return to your preset countdown time.
Note: At the end of the countdown the timer automatically starts to count up from zero.
This new function is to advise you how much time has elapsed since the alarm went off.
RETURN TO NORMAL TIME
Push the MODE button 5 times. (The timer will continue to count down even in normal
time mode and the chime will sound when preset time is finished. Push any button to
turn off the chime.)
CH CHRONOGRAPH OPERATION (Stop watch):
• From NT mode push the MODE button 3 times.
• CH is displayed in the fourth box from the left. 00:00:00 displayed.
• Push START/STOP and the 100th of a seconds will count up followed by
seconds, minutes and hours.
• Pushing LAP/RESET during operation will stop the counter, you have 5 seconds to read the
split time and then the counter WILL continue the count. Or by pushing LAP/RESET again
during the 5 seconds will start the counter from the new accumulated time.
