2
1.
click the “Settings”
2.
click “General”
3.
click “Bluetooth”
4.
Turn it ON, and search the
Devices
5.
Select “Rxxxxxx” to connect
6.
When see the “Connected”
means the connection is OK.
(example: pairing with iPhone)
4.
Please complete the connection procedures as the above photos.
5.
After the connection is completed, the RED light will be OFF.
6.
Before using WordPad file or appropriate APP, please set keyboard language
of device to US language. Then, scan the barcodes and the barcode data
will show on the cursor side.
Notes:
*
This product complies with Bluetooth standards. This device that communicated with
this product must support the same SPP or HID. For other Bluetooth devices with
other profiles we cannot guarantee a connection before the product has been tested.
*
The communication speed and range of the product may vary due to obstacles and
radio wave condition between the product and device to which it is connected.
Condition on the host device may also affect the communication speed and range of
the scanner
LED Indicator Information
Orange LED ON
Full charged
Orange LED Flashing
Charging / Low battery
Red LED Continual ON
Off line / out of service
Red LED ON
Not read
Green LED ON
Good read
Orange LED ON
Good read (Batch mode)
Remark:
*
When the battery power is too low, the Orange LED will flash and beep
once. Scanner should be charged immediately.
*
In case the power consumed out totally; the RTC (Real Time Clock) will back to
original setting 01012000.
*
If scanner shuts down it is recommended to charge it fully before turning
it back on.
*
Under power-saving mode, there will not be LED indication when charging.
Reset Configuration to Defaults
(scan from A1 to A6 for HID profile or B1 to B5 for SPP profile)
HID profile
SPP profile
A1
B1
A2
B2
A3
B3
A4
A5
B4
Make sure you hear the beeper sound, then,
scan next barcode to complete setting.
A6
B5
There are two operating modes on the scanner
1.
Data Transmission mode (Default)
It is a necessary to scan “clean memory data" when
switching between these two modes.
Within Bluetooth radio
range
Beyond Bluetooth radio range
Data
read
Transmit data to
smartphone/tablet directly
Save data into scanner’s memory,
scanner will transmit data to
smartphone/tablet automatically
when back to Bluetooth radio
range.
Enter Data Storage mode
LED
Green/ Orange LED flashes
followed by 3 beeps.
2.
Data Storage mode (Batch Mode)
It is a necessary to scan “clean memory data" when
switching between these two modes.
Data
read
Save data directly to scanner’s memory, It will transmit the data to
smartphone/tablet after you scan the Transmit memory data
code. To delete data please scan the Clean memory data code.
Enter Data Transmission mode
LED Green/Orange LED flashes followed by 3 beeps.
Always Clean memory data before switching to Data
Transmission Mode.
Otherwise Red/ Orange LED will flash with one long beep and will
not switch modes.
Under Data storage Mode
The data can be kept or deleted after data transmission
Keep the data
(Default)
Delete the data
Transmit memory data
Green/Orange LED Flashes followed by 3 beeps
Clean memory data
Green/Orange LED flashes followed by 3 beeps
The barcode data which is stored in the memory will be deleted.
Demo
+%-$.1
Demo
+%-$.1
Demo
+%-$.2
Demo
+%-$.2
Demo
LDC
Demo
LDC
Demo
LFC
Demo
+%-$.4
Demo
+%-$.4
Demo
%D%F%T
Demo
%D%F%T
Demo
%M%A%F
Demo
%M%A%N
Demo
%M%D%K
Demo
%M%D%E
Demo
%R%E%C
Demo
%E%R%A
