Rioned MULTI JET, User Manual

Page: 38 / 61

01/18 38
freeze flows out of the HP hose (watch the colour of the water).
14. Connect the HP-hose (with special connection) to the supply hose.
15. Open the supply valve ( 26 ).
16. Close the HP valve, when anti freeze flows out of the supply hose
(watch the colour of the water).
17. Next you connect the hose onto the anti-freeze tank ( C ).
18. Open the HP-valve again an let the pump sends all anti freeze to the
anti-freeze tank.
19. Close the high-pressure valve.
20. Switch off the machine.
21. Disconnect the hose and the special coupling an clean up.
Make sure that the HP and the supply hose are locked and tightened. Now the
machine is ready for departure!
Antifreeze can be recycled.
Ensure that not too much water is mixed with the antifreeze. If too much water
gets into the antifreeze, it is not suitable for re-use. Dispose the used antifreeze
properly, hand it into a local depot for disposal of industrial waste.
7.3 Pulsator system
Purpose : With less water use, quicker to the stoppage.
Construction :
The high-pressure pump has three cylinders. By normal use the three cylinders
follow each other continuously. This gives a fluent volume stream. To stop one
stroke, you get a pulsating water stream.
Control :
Manual: To close or open the valve ( 16 ), you start or stop the pulsator.
Control box: Use switch “RioPulse On/Off”.
Riomote: Use the switch handle on the transmitter.
Use :
Use the pulsator system only to get quicker to the stop-
page. Stop the pulsator when you are to the stoppage.
Reel out with the hydraulic control and not touch the HP
hose while the Riopulse is on!
Use the machine mentioned earlier in this user's manual.