5)
Use Ø150mm pipe (flexible if possible) and fix it with
a pipe-tightening ring (not provided) at the
reduction fitting.
6)
Connect the pipe to the outdoor duct.
Note: If for (Internal) recirculation mode, please install
the charcoal sponge behind the aluminium filter.
Installation of external motor:
1)
Remove the screws on the cover
2)
Drill 4 holes and install the motor
3)
Install/screw back the cover
4)
Connect the cables
INSTALLATION
En
glis
h
Before drilling any holes, check the area to be drilled to
be clear of any electrical cables or pipes…etc.
Note:
Whenever possible, protect the top of the hob with
cardboard or similar materials to prevent breakage
during installation
1)
For both internal and external motor mode, please
cut a minimum of Ø165mm duct hole.
2)
Cut an installation hole at the bottom of the cabinet
as per figure 1 or 2.
3)
Lift the hood into the wall cabinet: Ensure that the
appliance is mounted on a solid surface that can
withstand the appliance’s weight. The two pieces of
installation brackets enclosed will clip with the
board.
Installation must be performed by qualified personnel only. The
manufacturer declines all responsibility for improper installation
and does not accept responsibility for appliance warranty in the
event of damage caused by incorrect installation.
4)
Tighten the screw on the 2 sides of the
installation brackets.
Fig.1
Fig.2
For 80cm of hood
4
