3
HOW TO USE
•
Preparation and Verifi cation Before Use
Preparation
•
Make sure that the burner control knob is
at the “OFF” position and then fully turn on
the gas valve.
•
Fill the water tray with water to approximately
half level.
•
Open the top plate.
•
Pull out the heat shield plate towards you.
CAUTION
•
If the griller is used without filling the water tray
with water, the oil and fat deposited on the water
tray may catch fire. Be sure to fill the water tray
with water to approximately half level before use.
•
During use, make sure from time to time that the
water tray is filled with water without a lot of oil and
fat deposited. If the oil or fat deposited on the tray
starts splashing, be sure to replace water on the
tray to remove oil and fat. If the water tray is used
without replacing water, the splashed oil and fat
may catch fire. Caution should be exercised during
water replacement as the water tray may be very
hot.
•
Using the griller with its top plate closed may result
in failure. Be sure to use it with its top plate open.
•
How To Use
1 Ignition
•
Push the burner control
knob and slowly turn
counterclockwise (towards
ON direction) until it stops.
•
A click sounds and the pilot burner is ignited. Keep the
knob pushed in and turned for a few seconds until the
main burner is ignited.
•
Wipe the main unit with a clean cloth.
•
Wash the grate, heat shield plate, rotisserie
sticks and water tray using neutral detergent
and then wipe them with a clean cloth.
When using this appliance for the first time
CAUTION
CAUTION
•
Do not bring your face too near the burner
during ignition. Burn injury on the face may occur
due to flame or heat.
Caution on high
temperature
Verifi cation
•
No flammable object such as paper, plastic, oil and spray can is placed near the appliance.
•
The rubber hose is not cracked, excessively bent or in contact with the griller.
•
Ignite the main burners by turning the
burner control knobs one by one.
•
When the burners are ignited for the first
time, the ignition may not be smooth due
to the air trapped in the rubber hose. In
this case, repeat the ignition operation
few times until the air is released. If the
ignition attempt fails, turn the burner
control knob back to the original position
and then make another ignition attempt.
Ignition may fail if the knob is turned too
fast.
Push and turn
(OFF)
(ON)
- 9 -
Summary of Contents for RGP-43SV
Page 15: ......
