6
Ring Alarm Motion Detector – Exclusion
Removing Ring Alarm Motion Detector from a Z-Wave Network
Exclusion Instructions:
1. Initiate remove “Ring Alarm Motion Detector” flow in the Ring Alarm mobile application – Select the
settings icon from device details page and choose “Remove Device” to remove the device. This will
place the controller into Remove or “Z-Wave Exclusion” mode.
2. Locate the pinhole reset button on the back of the device in the battery compartment.
3. With the controller in Remove (Z-Wave Exclusion) mode, use a paper clip or similar object and tap
the pinhole button. The device’s red LED turns on solid to indicate the device was removed from
the network.
Ring Alarm Motion Detector – Factory Reset
Factory Default Instructions
1. To restore Ring Alarm Motion Detector to factory default settings, locate the pinhole reset button on
the device. This is found inside the battery compartment on the back of the device after removing
the back bracket.
2. Using a paperclip or similar object, insert it into the pinhole, press and hold the button down for
10 seconds.
3. The device will rapidly blink green continuously for 10 seconds. After about 10 seconds, when the
green blinking stops, release the button. The red LED will turn on solid to indicate the device was
removed from the network.
Note
Use this procedure only in the event that the network primary controller is missing or
otherwise inoperable.
Wake-Up Notification
Not applicable. Ring Alarm Motion Detector is a Frequently Listening Receiver Slave (FLiRS) device and
does not support Wake Up Command Class.
