ring Alarm Keypad 2nd Generation User Manual Download Page 12

12

To review your warranty coverage, please visit 

www.ring.com/warranty

© 2020 Ring LLC or its affiliates. 
Ring, Always Home, and all related logos are trademarks of Ring LLC or its affiliates.

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible  
  d’en compromettre le fonctionnement.

CAN ICES-3 (B)/NMB-3(B)

In accordance with FCC requirements of human exposure to radio frequency fields, the radiating 
element shall be installed such that a minimum separation distance of 20 cm is maintained from the 
general population.

Conformément aux exigences d’Industrie Canada 
en matière d’exposition humaine aux champs de radiofréquences, l’élément rayonnant doit être 
installé de telle sorte qu’une distance minimale de 20 cm soit maintenue par rapport à la population 
générale.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment.

AVERTISSEMENT : Tout changement ou modification à cet appareil qui n’a pas fait l’objet d’une 
autorisation expresse par la partie responsable de sa conformité pourrait annuler le droit pour 
l’utilisateur d’opérer l’équipement.

CAUTION: To reduce the risk of electrical shock, DO NOT open the unit. There are no user serviceable 
parts inside the unit. Refer to customer support for any repairs.

ATTENTION : Pour réduire le risque d’électrocution, NE PAS ouvrir l’appareil. Aucune pièce interne n’est 
réparable par l’utilisateur. Veuillez vous référer au service à la clientèle pour toute réparation.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or 
equivalent type recommended by the manufacturer. Dispose of the used batteries according to the 
manufacturer’s instructions.

ATTENTION : Danger d’explosion si la pile n’est pas remplacée correctement. Remplacez la pile 
uniquement par une pile identique ou par une pile du même type que celle recommandée par le 
fabricant. Suivez les instructions du fabricant pour jeter les piles usées.

Summary of Contents for Alarm Keypad 2nd Generation













Reviews: