ring Alarm Keypad 2nd Generation User Manual Download Page 11

11

Supplier’s Declaration of Conformity – Compliance Information Statement

Unique Identifier: Ring Contact Sensor

Responsible Party and Party issuing Supplier’s Declaration of Conformity 
Ring LLC dba Ring 
1523 26th Street 
Santa Monica, CA 90404 U.S.A. 
www.ring.com / [email protected]

FCC Compliance Statement (for products subject to Part 15)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or 
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver  
  is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Innovation, Science and Economic Development Canada (ISED) Compliance

This device contains licence-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science 
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following  
two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation  
  of the device. 

Conformité Innovation Sciences et Développement Économique Canada (ISDE) L’émetteur/récepteur 
exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et 
Développement économique Canada applicables aux appareils radio exempts de licence. 
L’exploitation est autorisée aux deux conditions suivantes:

1. L’appareil ne doit pas produire de brouillage.

Summary of Contents for Alarm Keypad 2nd Generation













Reviews: