Amigo I
I
2
110654_G
4. Align the printer.
a. Slowly move the
lift arm
down until the disc just touches the print pad.
Printer
Button
Lift
Arm
Side to Side
Alignment
Print
Pad
Holding
Pins
b. If the disc is not centered side to side on the print pad, align the printer side to side.
i. Loosen
the
side to side screws
.
ii. Slide
the
printer
, not the print drawer,
until the side edges of the disc and
printer pad are aligned.
iii. Tighten
the
side to side screws
.
Side to Side
Screws
Front to Back Screw
c.
Using either the T25 Torx driver or the
5/32” Allen wrench, turn the
front to back
alignment screw
until there is a 1/16”
(1.5mm) gap between the front edge of the
disc and the raised edge of the disc
retainer.
Gap
Disc
Retainer
5. Raise
the
lift arm
out of the way of the print drawer.
6. To close the print drawer, press the
printer button
.
7. To release the disc from the gripper, press the
disc release button
.
Tip:
Place your hand under the disc to catch it.
