7
Figure 3
Figure 4
Base and Column Assembly
1. Place the base (A-Fig. 1) on a level floor where
the machine will be used.
2. Attach the column (B-Fig.1) to the base (A-Fig.
1) using four M8x20 hex bolts. Tighten all four
bolts.
3. Using an allen wrench (C-Fig. 2) remove the
column collar (D-Fig. 2) as shown.
4. Insert the worm elevation gear (E-Fig. 3) into
the table support bracket (F-Fig. 3) as shown.
5. Place rack (G-Fig. 4) inside the table support
bracket (F-Fig. 4) lining up the teeth as shown.
6. Slide the table support and rack assembly over
the column and replace the column collar.
C
D
Figure 1
Figure 2
Assembly
B
A
Head Assembly
1. Place the drill press head (A-Fig. 5) onto the
column (B-Fig. 5) as far as it will go.
Assistance is needed for this next step.
B
A
Figure 5
NOTE:
