11
ADJUSTMENTS
REPLANING
using the REPEAT CUT
1. Remove the screws to take
off the height adjustment hand-
wheel (1 screw), remove the
right side panel (3 screws) and
top cover (4 screws). FIG. 5.
2. Lower the cutterhead
assembly until the stop screw
stops on the step block.
3. Plane a scrap piece of wood,
then measure the thickness of
the finished piece. It should be
the same as the thickness scale
and repeat cut indicator.
4. If an adjustment is necessary,
use a wrench to loosen the lock
nut and adjust the stop screw to
correct the height.
5. Once the adjustment is made,
retighten the lock nut and the
stop screw securely.
THICKNESS SCALE ADJUSTMENT
Located on the right front of the planer, the thickness scale
shows the depth of the finished workpiece.
Inaccurate cuts can be prevented by routinely checking the
alignment of the thickness scale.
1. Table extensions must be level with planer table.
2. Plane a scrap piece of wood, then measure the thickness of
the finished piece.
3. If properly adjusted, the thickness of the finished piece
should be the same as indicated on the scale.
4. If out of adjustment, loosen the two screws holding the
scale indicator and adjust the scale indicator, up or down, to
point to the correct setting on the scale.
5. Retighten the two scale indicator screws securely.
THICKNESS
SCALE
SCALE
INDICATOR
& SCREWS
6. Install the right side panel, top cover and height
adjustment handwheel back onto the planer.
FIG. 5
FIG. 6
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ALL ADJUSTMENTS ARE
COMPLETE.
LOCK
NUT
STOP
SCREW
STEP BLOCK
STEP
BLOCK
