17
ADJUSTMENTS
INFEED / OUTFEED EXTENSION SUPPORTS
The overall table length can be expanded from
30-1/2” to 51-1/2”. This can be done by loosening the
four extension table lock knobs (A-Fig 28). Extend the
supports to the desired lengths and tighten the four
extension table lock knobs.
The infeed and outfeed extension supports are
adjustable to be level with the main table if ever
necessary. These are set at the factory. If after
planing or edge joining a work piece and adjustment
is necessary, follow these instructions:
1. Place a straight edge on the outfeed table across
the outfeed extension support and check for level.
2. The straight edge should lay flat on the outfeed
table and the outfeed extension support. The straight
edge should just touch or leave a small gap from the
outfeed extension support. Figure 29.
3. If level adjustment is needed, loosen the extension
table lock knobs (A-Fig 28).
4. Loosen the locking set screw on the bottom-side of
the extension support. Figure 30.
5. Do the same measurement with the straight edge
from the infeed table, to the same insert cutters that
were used to measure the outfeed table.
6. Once the infeed and outfeed tables are aligned with
the cutterhead cutters, the tables need to be checked
to confirm that their surfaces are parallel with each
other - ends not tilting or angling down or up from the
cutterhead.
5. Lie the straight edge across BOTH tables. FIG. 27.
They should be set at the same height and perfectly
level to each other.
- If it does, the tables are true to each other.
- If the straight edge does not lie flat across both
tables, then the tables must be adjusted. Tune the
outfeed table to the infeed table.
6. Adjust the angle and tilt of the outfeed table with the
slotted screws as described in steps 4 A-C.
FIG. 27
CONTINUED FROM PAGE 16
FIG. 28
A
B
A
A
A
A
FIG. 29
Straight edge should touch or
have a small gap
FIG. 30
A
A
