8
MultiAir fan
Enabling the Multi Air fan (ON) you get access to fan speed and fan
adaptation�
Fan level
The volume of convection air is adjustable from AUTO (adapts
automatically according to heating power), over to Level 1 (min) and
level 5 (max)�
Fan area
In addition, it is possible to adapt the Multi Air fan speed (AUTO,
level 1 to level 5) /- 30 % of fan speed�
Frost protection
Note
Only possible if a roomsensor is connected�
If this function is enabled (ON) and if the room temperature drops
below the set value (4 °C - 10 °C), your stove will start working�
This applies also outside the heating times and in operating state
STOVE OFF
�
RIKA room sensor
For more information on this option, please consult the operating
instructions room sensor / RIKA radio room sensor�
Room temperature
Display of the current room temperature in degrees Celsius�
Temperature adjustment
It is possible to adjust the temperature shown in the infomenu�
Overheat protection
The stove switches to burn-off if the room temperature exceeds
30 °Celsius�
Power requirement
factory setting 3
The heating power is adjustable from level 1 (for small rooms) to
level 4 (for big rooms)�
Modulation
When modulation is activated, you can adjust the hysteresis from
0�5 - 1 °Celsius�
RIKA firenet
For more information on this option, please consult the operating
instructions RIKA firenet�
GSM
For more information on this option, please consult the operating
instructions RIKA GSM Control�
Screensaver
When the screensaver is activated (ON), you can choose between
the modes
Classic
,
Info
and
Dark
�
Q
Classic:
RIKA sustainability-themed screensaver
Q
Info:
Actual and nominal temperature or heat output (depending
on mode, only possible with RIKA room sensor connected)
Q
Dark:
a darkened screen
In the
Advanced
menu, you can set the delay time in minutes
(1 - 60 min) and the brightness� Adjusting the brightness is not
available for Dark mode�
Child lock
Note
Only possible with the screensaver activated�
If this function is enabled (ON), a 4-digit code can be saved� Await
the activation of the screen saver�
The stove can only be operated with the saved code�
Hotel mode
Note
Only possible with the screensaver activated�
Enable the child lock (ON) and save a 4-digit code� Enable the hotel
mode� Await the activation of the screen saver�
You can only press the buttons
ON / OFF / PLUS / MINUS
� Now a
selection of further functions is only possible by entering the saved
code�
Date/time
Sets date and time�
Language
Selects the desired language�
Tip
Both language selection and setting of date and time must only be
carried out on initial operation�
Resets
Note
This reset may only be performed if the stove temperature is below
80 °C!
Kg till cleaning
Resets the supply rate after a service has been carried out�
Factory setting
Resets all stove settings to the factory setting�
WLAN Setup
Reset WLAN Setup�
Logging
Only for service technicians�
Service
Only for service technicians�