Rigid Industries HOOD MOUNT 46549 Installation Instructions Download Page 4

Page: 4 / 4

Follow us on facebook at

Facebook.com/RigidIndustries

779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 • www.rigidindustries.com

PKG-IS-184-A

Rigid Industries, Rigid, SR-Series, are registered and/or common law marks owned by

JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.

For warranty information, visit www.rigidindustries.com/about/warranty

WARRANTY INFORMATION

Your installation is now complete.

Welcome to the Rigid Nation!

Wiring: Wire your lights according to the instructions included with the light.

Take care to avoid any heat sources and sharp or abrasive surfaces.

step 6

Install Rigid Industries light using hardware provided with the light.

See Figure 6.

Figure 6

Figure 7.

Figure 6.1

Summary of Contents for HOOD MOUNT 46549

Page 1: ...es If you are not confident in your mechanical skills please seek the help of a professional to perform the installation Please read through all of these instructions and tips before proceeding with t...

Page 2: ...ng vent tubes on the square bar under the hood See Figure 3 step 2 Remove hood then tape off the three marked tabs Use tape as guide to cut tabs off Remove tabs See Figure 2 Figure 7 Figure 2 Figure 2...

Page 3: ...Industries mount with 3 1 4 20 X 5 8 Hex Head Self Drilling Screw See Figure 5 step 4 Center Rigid Industries mount and mark 3 1 8 holes to be drilled See Figure 4 Figure 7 Figure 4 Figure 4 1 Figure...

Page 4: ...liability company d b a Rigid Industries For warranty information visit www rigidindustries com about warranty WARRANTY INFORMATION Your installation is now complete Welcome to the Rigid Nation Wirin...