12 Pin Connector
This guide describes in detail the connection of each wire. Also included are possible applications of each
wire. This system was designed with the ultimate in flexibility and security in mind. Please read the in-
structions carefully to ensure a thorough understanding and how it operates; also see wiring diagram of
ALxxx-PLUS.
BLACK WIRE:
GND
Ground Input (-). The black wire must connect to a solid chassis ground. Clean away any paint or dirt to
ensure the best possible ground.
BROWN WIRE:
Indicators Lights
Positive Hazard Light Output (+). Connect the brown wire to the circuit that shows +12v or only when the
hazard lights are on. Right hazard light.
RED WIRE:
Power Supply
Main Power Input (+). Connect to the battery or constant power wire at the ignition switch with a minimum
25Amp supply.
Green/Black Wire:
Negative Output (-). 250mA Window Closer. 30 second negative output.
NOTE: MUST USE window closer module (optional extra).
BROWN WIRE:
Indicators Lights
Positive Hazard Light Output (+). Connect the brown wire to the circuit that shows +12v or only when the
hazard lights are on. Left hazard light.
Green Wire:
Trunk Release
Positive Output (+). Boot Release. Connect to the boot release motor.
NOTE: MUST USE RELAY (not supplied).
Pink Wire:
Siren
Positive Siren Output (+). Connect the pink wire to the siren of white wire.
Blue Wire:
Door Trigger
Negative Door Input (-). Connect to the Driver door pin switch circuit wire that shows ground (-) when the
door is open.
Note: Nearly all cars have negative door input. Consult owner manual for polarity.
Purple Wire:
Door Trigger
Positive Door Input (+). Connect to the Driver door pin switch circuit wire that shows +12v when the door
is open.
Note: Consult owner manual for polarity.
Orange Wire:
(Foot brake)
Positive Input (+). Connect the orange wire that shows +12v when pressing the foot brake.
Yellow Wire:
Immobiliser (engine stop)
Negative (-) 250mA. Connect the yellow wire to yellow wire to immobiliser relay
White Wire:
ACC (ON)
Ignition Output (+), Connect to the main ignition wire that provides 12v when the ignition is on and while
cranking the starter. Also, when the ignition is off, this wire should not show any voltage (0v).
page 9
Summary of Contents for AL Plus Series
