Riftek IDK-BT Series, User Manual

Page: 10 / 32

Wheel diameter measuring gauge, IDK-BT
IDK-BT [Revision 2.2] 4
th
September 2017
10
- indication discreteness of 0.01mm is accessible only in a mode of direct indica-
tion;
- the separation point is indicated at the top side of the screen in the reverse indica-
tion regime.
10.3. Image brightness set-up
To change the display brightness it is necessary to:

turn the power on (press Red button).;

press Blue button and keep it pressed for more than three seconds;

display will show " bt On " or " bt OF ";

press Blue button again until
“
brt X
” message appears on the display;

choose the necessary brightness value by Green button pressings;

to save the changed parameters press Red
button the display shows “
SAUE
”
message, press the Green button to confirm saving and Red to cancel saving
of the changed parameters;
At brightness choosing one should take into account that increased brightness
enhances power consumption and decreases the period till battery recharge moment.
10.4. Millimeters-Inches -Tapes display set-up
To change the mode it is necessary to:

turn the power on (press Red button).;

press Blue button and keep it pressed for more than three seconds;

display will show " bt On " or " bt OF ";

press Blue
button again until the either “
SI
” or “
Inch
” or “
Tape
” message ap-
pears on the display. “
SI
” – measuring results will be shown in mm, “
Inch
” –
measuring results will be shown in inches;
“
Tape
” – measuring results will be
shown in tapes.

choose the necessary value by Green button pressings;