Riello FAMILY KI, User Instructions

Page: 28 / 40

USER
28
1.5 Adjusting the heating
temperature
To adjust the temperature of the outlet
water, press the heating temperature
adjustment key .
A -
ENCODER
− The two digits will no longer show
the temperature measured instanta-
neously by the probe, but the tem-
perature (flashing) previously set.
− By rotating the encoder A, you can
raise or lower the temperature.
− When 3 seconds have passed since
the last modification, the value is
automatically stored and the dis-
play again shows the value meas-
ured instantaneously by the probe.
− The set temperature is shown both
numerically (e.g. 55°C) and via the
illumination of the comet.
− During the heating adjustment,
when passing from the minimum
value to the maximum value you
will meet the sector of the H.T.C.
system: Heating Temperature Con-
trol (from 55°C to 65°C).
The H.T.C. system independently manages
the outlet temperature adapting the op-
eration to the actual needs of the home.
When the heat requirement is prolonged,
the outlet temperature increases allow-
ing for a more rapid heating of the envi-
ronment.
Once the required comfort level has been
reached, the system brings the outlet tem-
perature back to the value set at the be-
ginning.
This ensures lower consumption, less
scale formation in the boiler, and reduced
temperature swings in the radiators.
1.6 Adjusting the heating
temperature with an external
probe connected
If there is an external probe, the outlet
temperature value is automatically cho-
sen by the system, which quickly adapts
the ambient temperature to any varia-
tions in the outdoor temperature.
The display shows the external probe
icon, and only a central segment is lit up
in the heating comet.
− If you want to modify the temper-
ature value, increasing or reducing
it in relation to the value automat-
ically calculated by the electronic
card, proceed as follows:
− press the heating temperature
adjustment key . The two digits
will show the number correspond-
ing to the set comfort level (factory
setting)
− rotate the encoder A to raise or
lower the chosen comfort level;
the two digits will show the num-
ber (+1, +2, etc. or -1, -2, etc.) cor-
responding to the chosen level.