3.12.4 SETTING UP INSTRUMENT BOARD
3.12.4.1 MODEL SELECTION
(Procedure to be performed every time the instrument power
supply is turned off).
Connect the battery to the vehicle.
The instrument board will alternately
display the two displacement ratings
of the vehicles featuring this instrument.
300
cc
125i
. identifies the
City Line
300 or 125
i.e. E3
125cc. identifies the
City Line
with carbutettor (Not use)
Turn the ignition key ON
When the vehicle’s displacement
appears on the display, press the
MODE key and hold it down until the
instrument board checks all segments
of the digital display.
Make sure the model selection is
correct.
Turn the key OFF.
(if you have chosen the wrong model you can modify this setting
by following the procedure described below).
Turn the ignition key ON
Remove the main 30A fuse (located inside the fuse box in the
compartment on the rear side of the upper fairing).
Wait (about 4-5 minutes) until there is no indication on the display.
Turn the ignition key OFF
Refit the 30A fuse inside its seat and repeat the model selection
procedure.
3.12.4.2 SELECTING UNIT OF MEASUREMENT FOR SPEED
(to perform this procedure, the vehicle must be halted and the
engine off)
Turn the ignition key ON
Press the MODE key and scroll through
all functions until you are displaying
ambient temperature.
Press the MODE key and hold it down for 3 or 4 seconds.
The display will show the unit of measurement set up for the
vehicle.
If the unit is correct, confirm by holding the MODE key down for 3
or 4 seconds.
If the unit of measurement is not
correct, give the MODE key a quick press
to change the unit of measurement
accordingly.
Confirm your choice by holding the MODE key down for about 3-4
seconds.
Turn the ignition key OFF
A wrong model or speed selection can lead to improper
operation of the instrument board (e.g. speed, RPM,
temperature of coolant, fuel level indicators, etc.).
4
5
6
english
2
0
1
3
2
