5
1. Carefully slide the filter over the filter
cage, sliding it over the center ring
covering the 3 slots until the filter stops
against the lid.
2. Place filter nut and filter plate onto
threaded stud and tighten it down.
Finger tighten only.
NOTE:
Lever of filter nut should be away
from plate as shown.
IMPORTANT:
Do not overtighten as this
may deform or crack the filter cage, or
filter.
NOTE:
If filter cage or float needs to be
replaced or removed, use a flat blade
screwdriver and insert the blade near one
of the tabs between the filter cage and
the center ring of the lid. Pry the tab out
of the slot. Tilt the cage and lift away from
the lid. To replace, follow the assembly
instructions below:
Replacement Filter Assembly
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac
with any parts damaged or missing.
Filter Cage
Filter Nut
Lever
Filter Nut
Filter Plate
Filter
Slots (3)
Threaded
Stud
WARNING: Do not operate with
filter cage and float removed. The
float prevents water from entering
the impeller and damaging the
motor. The cage prevents fingers
from touching the moving impeller.
!
!
3. Place the float over the opening in the
center of the lid with the words "This
Side Towards Lid" laying face down
over the hole.
4. Line up filter cage tabs with slots in the
center ring of the lid.
5. Push on the filter cage until the tabs
snap into slots for a secure fit.
WARNING: To reduce the risk of
personal injury or damage to vac be
sure to keep hands, fingers, or any
other foreign objects out of the
center opening when assembling the
float .
Filter
Cage
Tabs (3)
Slots
(3)
Power
Assembly
THIS SIDE
TOWARD LID
Filter
Cage
Tabs (3)
Float
Solid End
Slots (3)
!
SP6662 ES.qxd 3/16/07 9:08 AM Page 5