RIDGID RB32 Operator'S Manual Download Page 1

For Models RB48 and RB60:

• Do 

NOT 

put fuels, flammables, explosives or hazardous 

materials inside these products.

• Gasoline, solvents, gun powder or other munitions, 

dynamite, propane, acetylene or other such products can 
explode if stored inside these products.

• Use these products 

ONLY

 for storing and transporting 

electric or hand tools and equipment, and other similar 
materials.

•  Failure to follow these warnings or modifications or other 

uses of these products could result in death, serious injury 
or property damage.

OPERATORS MANUAL

MODELS RB32, RB48, RB60

RIDGID ON-SITE STORAGE EQUIPMENT

DANGER

–NOTICE–

 

 

 

 

Keep hands clear when closing lid. Failure to do so could result in severe injury.

WARNING

Read and understand all instructions and warnings before operating or using this product. 

–ATTENTION–

To prevent electric shock, explosion, fire and/or serious 
personal injury when using storage chest with:

Extension Cord -

• Follow all Extension Cord manufacturer’s Warnings 

 

and Instructions.

• After removing knock-out, insert RAPID PASS

® 

rubber 

grommet.  Do 

NOT

 insert extension cord through hole 

without grommet in place (see figure 8, on page 3).  

•  Only use a three-wire extension cord with all three prongs 

intact.  Never remove the round grounding prong.

• Extension cord must be connected to a 120 Volt GFCI 

protected outlet with proper ground.  If GFCI outlet is 

 

not available, use an extension cord with GFCI protection 
built in.

• Check the insulation and plugs of extension cord before 

using.  Do 

NOT

 use cord if it is worn or damaged.

• Do 

NOT 

overload extension cord.

•  Remove extension cord from the RAPID PASS

®

 hole before 

moving or transporting storage chest.

•  Only use an extension cord that is rated for outdoor use.

• Do 

NOT

 connect extension cord to outlet that also supplies 

critical safety equipment with power.

Cordless Power Tool Battery Chargers -

•  See Charger’s Owner’s Manual for proper use and care of 

charger and batteries.  Follow all Warnings and Instructions 
provided with your battery charger.

•  Place chargers and electrical connections in tray.
• Chargers are Dry location use only.  Do 

NOT

 expose to 

liquid, vapor, or rain.  Should your charger become wet, Do 

NOT

 attempt to use.  Unplug extension cord from supply 

before handling wet charger or cords.

• Only use chargers and batteries that are intact and 

operating properly.

• Do 

NOT

 touch metal prongs when plugging charger into 

extension cord.

• Keep flammable materials like paper or rags away from 

charger, cords or connections.

• Do 

NOT

 place or attempt to charge lead acid, car type 

batteries in storage chest.

WARNING

Any modification or unintended use of this product shall 
immediately void all manufacturers warranties. Manufacturer 

disclaims all liability for injuries to persons or property result-
ing from any modification to, or unintended use of this product.

Summary of Contents for RB32













Reviews: