RIDGID R829, Operator'S Manual

Page: 6 / 32

6
WARNING:
The safe use of this product requires an
understanding of the information on the tool and in
this operator’s manual. Before use of this product,
familiarize yourself with all operating features and
safety rules.
CAUTION:
If at any point during the charging process none
of the LEDs are lit, remove the battery pack from
the charger to avoid damaging the product. DO
NOT insert another battery. Return the charger and
battery to your nearest service center for service
or replacement.
CHARGING THE bATTERy pACk
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it until the light on front of charger changes
from flashing green to continuous green.
NOTE: Batteries will not reach full charge the first time they
are charged. Allow several cycles (operation followed by
recharging) for them to become fully charged. This is normal
for nickel-cadmium batteries.
TO CHARGE

Charge the battery pack only with the charger provided.


Make sure the power supply is normal household voltage,
120 volts, 60 Hz, AC only .

Connect the charger to a power supply.

Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack onto the charger.
See
Figure 1.

The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.

Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.

For average charge times, refer to the chart on the
following page.

When the batteries become fully charged, unplug the
charger from the power supply and remove the battery
pack.
OpERATION
Fig. 1
CHARGING A HOT bATTERy pACk
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, the green LED will be off and the red
LED will begin flashing.
When the battery pack cools down to approximately 104°F
(40°C), the charger will automatically begin fast charge
mode.
CHARGING A COOL bATTERy pACk
If the battery pack is below normal temperature range, the
red LED will begin flashing and the green LED will be off.
When the battery warms to a temperature of more than 41°F
(5°C), the charger will automatically begin fast charge mode.
NOTE: Refer to CHARGING THE bATTERy pACk for
normal recharging of batteries. If the charger does not charge
your battery pack under normal circumstances, return both
the battery pack and charger to your nearest repair center
for electrical check. For the location of your nearest repair
center, please call 1-866-539-1710.
CHARGER
BATTERY PACK
GROOVES